THE 6 QUIGLEYS

Home | Photos | Popup | Tow Vehicle | Hybrid Trailer
Grey Water Tanks

Our different attempts at collecting Grey Water from our Sink & Shower

This is a photo of how we originally collected grey water. The 1 1/2" adaptor Coleman supplied connected to a piece of 3/4" garden hose, and collected in an old 5 gallon bucket.

Our improved system, using a Y fitting to vent the drain line. I have since found the problem was the fittings I was using were reducing the inside diameter of the hose from 3/4" to 3/8", which was slowing the flow and causing the need for the vent.

old-drain.jpg

grey1.jpg

PHOTO 1

grey2.jpg

PHOTO 2

grey3.jpg

PHOTO 3

grey4.jpg

PHOTO 4

new-drain.jpg

PHOTO 5

dualtotes.jpg

I then started reading what other people on POPUP TIMES had done with their Grey Water system. The cheapest solution was to buy a 7 Gallon Aqua Tainer from Walmart for $7.35, and use it to collect the grey water. The cap has a 3/4" threaded hole with a faucet which can be used to dispense the water in the container. Instead we use this hole for our 3/4" garden hose to connect to.
It still drained slowly, so my next step was to remove the 1 1/2" by 3/4" drain adaptor that Coleman supplies, and use 1 1/2" pipe. I checked my box of left over pipe pieces, and found a 1 1/2" P trap fittings will connect to the oudside drain fitting on the coleman.
Next step was to modify the cap of the Aqua Tainer.
PHOTO 1
This photo shows the before and after of the cap from the Aqua Tainer pulled apart with the Cap, white washer and faucet.
I then cut a a hole 2 inches in diameter in the cap, basically following the lip inside that held the white washer in place.
I then pared away the lip with a stanley knife.
PHOTO 2 
This shows the 8" pipe with elbow I got at Ace hardware for $1.49. The same at Home Depot with the nut was $2.49.
I bought the washers at Ace hardware for 98 cents each.
They were 3 inches in diameter, so I had to trim them to 2 3/4 inches to fit inside the cap.
The inside hole of the washer was slightly less than 1 1/2 inches, a nice snug fit for a 1 1/2 inch pipe.
PHOTO 3
This shows the cap in place with the black washer, ready for the pipe.
The nut that holds the pipe to the popup is a standard 1 1/2 inch, that I had plenty of at home from replacing sink drains.
PHOTO 4
Here we have everything in place ready to hook up to the popup.
PHOTO 5
The nice thing with this set up is I don't need a vent, as the pipe is big enough in diameter to allow air and water to flow freely.
Also the fitting Coleman supplies always keeps some water in the outlet fitting as the 3/4 inch connection is centered not at the bottom of the fitting. I have tried it and am really happy with how quickly the sink drained, compared with using 3/4 inch hose connections.
The total cost for 2 Blue Totes and fittings was less than $20

Click on the photos for a larger picture. E-mail me with any questions, or improvements.